EDGE Engine Control Cable Mercruiser® & Gen II Controls-15ft (457.2cm)
Engine Control Cables EEC-036-XX (XX is the cable length in feet) are used for Shift and Throttle application. Different designs of Engine Control Cables are used depending on the engine type and installation.
Multiflex offers a wide variety of Engine Control Cables for different applications. Engineered out of corrosion-resistant materials and components these control cables meet or exceed all industry standards.
Multiflex Engine Control Cables are interchangeable with the most common SeaStar Solutions®, Morse®, and Ultraflex® Engine Control Cables.
Refer to the Cross-reference Chart for interchangeability.
Applicable for Mariner® Engines up to 40 Hp.
Travel: 80 mm | EDGE Conduit: 8.6 mm | Inner: 2.75 mm (Coated Inner)
Special Edge Conduit
The unique design of Conduit provides structural integrity and a tighter minimum bend radius.
Improved Efficiency
Edge cables provide significantly greater efficiency due to the use of low-friction materials and construction.
Minimal Backlash
Edge cables allow an optimum gap between the inner core and conduit, resulting in significantly minimal backlash.
Less Friction Wiper Seal
The wiper seals are made from polyurethane impregnated with lifetime lubricant to minimize operating friction.
Cable Bend Radius
Edge Cable has a minimum bend radius of 4 inches. However, keep the bend radius as large as possible and the degree of bend to a minimum for optimal performance.
The above features translate into improved efficiency with reduced operator effort when using EDGE cables.
